QMS CrownCopy Guide d'installation télécharger pdf (Page 45)

2!&1



+/"010$%

7 Reinstall the controller board panel on the printer.

8 Tighten the two screws.

9 Push the fuser unit back in.

10 Close the printer’s front cover.

11 Reconnect all interface cables.

12 Reconnect the power cord and turn on the printer.

»Note:

In compliance with UL guidelines, “The appliance inlet is

considered to be the main disconnect device.”

13 Print a startup page.

Check that the startup page indicates the font SIMM just installed

under “Options.”

It’s identified as

cartridge2%

5 Insert the font

SIMM into the

font SIMM connector.

The font SIMM

connector is smaller

than the RAM SIMM

connector. Hold the

SIMM at a 45° angle to

the controller board,

with the notch on the

right side and the

bottom edge of the

SIMM in the connector.

6 Tilt the SIMM up toward you to a 90° angle until you feel it

snap into place.

When seated, the SIMM stands upright, firmly in place.





 Caution:

If you can’t snap the SIMM into place, don’t force it.

Reposition it, making sure that the bottom of the SIMM is seated

completely in the connector.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 125 126

Pas de commentaire

QMS CrownCopy Guide d'installation Page 45