QMS VMS Guide de l'utilisateur télécharger pdf (Page 38)

HSL Network

Application

VMS Interface for QMS Crown Printers2-22

2 Type the following commands:

$ SET DEF SYS$COMMON:[sysexe]↵

$ @qms$inithsl↵

» Note:

This command procedure works without modification for

most sites but you should review the command procedure before

running.

Once these two steps are completed, the HSL application is active

and ready to receive printer error and backchannel messages.

Phase V Installation

The HSL installation routine checks for DECnet Phase V. If Phase V is

detected, NCL creates the HSL session control application on the

running system. The NCL command procedures used by the system

at start-up to configure the network are appended with the necessary

information for generating the HSL application at system start-up

time.

Phase V HSL installation prompts are as follows:

Checking NCL for the existence of the session

control application HSL

If HSL has already been installed, you’ll see this message:

The session control application HSL is already

defined!

If HSL has not been previously installed, you’ll see this message:

Creating the session control application HSL

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 117 118

Pas de commentaire

QMS VMS Guide de l'utilisateur Page 38