QMS VMS Guide de l'utilisateur télécharger pdf (Page 83)

8VLQJWKH

'(&7(.

(PXODWLRQ

'(&7(.(PXODWLRQ

<ESC>[?38h

The printer makes these preparations for Tektronix emulation after

receiving the DECTEK sequence:

 If the printer's page buffer contains any data, the printer performs

a form feed. If the buffer is empty, the printer does not perform a

form feed.

 The printer saves the current state of ANSI mode (non-DECTEK

mode). The printer will restore this state after exiting DECTEK

emulation.

 The printer establishes the DECTEK mode “page” and selects

DECTEK fonts.

 The printer resets to their defaults any DECTEK modes that may

have been previously changed.

([LWLQJ'(&7(.(PXODWLRQ

To leave DECTEK emulation, use one of the following escape

sequences:

<ESC>[?38l

<ESC>[!p Soft Terminal Reset (DECSTR)

The DECSTR command also resets the printer to its power-up state.

For more information, see DECSTR, in chapter 3, “Printer Status and

Reset Commands.” Do not use the RIS (Reset to Initial State) escape

sequence (<ESC>c) to exit DECTEK emulation. During DECTEK

emulation, the printer interprets the RIS escape sequence as a valid

DECTEK command.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 137 138

Pas de commentaire

QMS VMS Guide de l'utilisateur Page 83