QMS PS 410 Guide de l'utilisateur télécharger pdf (Page 38)

Printing on Labels Adhesive label stock has pressure-sensitive

(peel and stick) adhesive backing. The procedure for feeding labels

is almost the same as for regular paper; however, you must use the

face-up output tray and load label-side down to prevent labels from

coming loose from the backing sheet. Use only labels

recommended for laser printers. Follow the specifications for labels

contained in the “Technical Specifications” appendix.

Label data should be formatted within your software application

program. Try printing your data on a plain sheet of paper first to

check its placement. This reduces the number of label sheets you

use.

Printing on Transparencies Use only transparencies recom-

mended for use in laser printers and always use the face-up output

tray. The transparency film should be able to withstand

temperatures up to 200 degrees Fahrenheit (93 degrees Celsius.)

Transparencies are especially sensitive to a dirty paper path. If

shadows are apparent either on the top or the bottom of the sheets,

produce a cleaning page to clean the printer’s rollers (see the

“Printer Maintenance” chapter).

NOTE: You should remove each transparency from the output

tray immediately after printing to prevent jams of

subsequent sheets.

Printing on Envelopes Envelopes may be printed from either the

standard tray or the optional envelope cassette. If you use the

standard tray, feed only one envelope at a time. If you use the

envelope cassette, load envelopes as shown in figure 2.7, that is,

face down with flap-side of the envelope toward the control panel

side of the printer.

Chapter 2

2-12 Printer Use

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 287 288

Pas de commentaire

QMS PS 410 Guide de l'utilisateur Page 38