QMS PS 410 Guide de l'utilisateur télécharger pdf (Page 58)

The command goes into effect immediately when you enter the

parameter.

NOTE: You may use this command as an end-of-file marker. For

example, if you know that you want to exit HP PCL

emulation at the end of a particular job, you may insert

the command at the end of the file and your next file prints

in the desired mode.

Returning All Ports to the ESP Default

If you experience problems either entering or exiting a printer

language, you may return the printer to its default ESP mode by any

one of the following:

1. Enter the PS Executive Utilities’ Special Menu and choose

“Reset Default Parameters."

2. Send the following PostScript command if you are in ESP or

PostScript mode:

serverdict begin Ø exitserver

statusdict begin

resettodefaults

3. Return ports to factory default through the Control Panel using

the following procedure:

a. Turn off the printer.

b. Hold down the TEST/CANCEL and ONLINE/OFFLINE

buttons.

c. Turn on the printer while keeping the buttons down.

Chapter 3

3-12 Selecting Printer Languages

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 287 288

Pas de commentaire

QMS PS 410 Guide de l'utilisateur Page 58