Administration / Engine
Use the Administration /Engine menu (fig. 4.12) to set print engine
defaults.
Image Alignment Adjusts the horizontal and vertical offset for
placing a printed image on the page.
Horiz Offset (3 digits; default 100; range 000-300)
Vertical Offset (3 digits; default 100; range 000-300)
Use the calibration tickmarks on the last page of the status page to
adjust these pixel (dot) values. See chapter 5, the “Printing a Status
Page” section, for information on how to print the status page. Then
measure the distance from where the tickmarks meet to the left and
bottom edge of the paper. Both measurements should be 0.5." If
not, use Image Alignment to move the image in pixel increments
(
1
⁄
300
").
Configuration
Menu
Administration/Engine
❏
❏
❏
❏
❏
❏
❏
❏
❏
❏
❏
❏
Image Alignment
Default Paper
Inputbin 1 Name
Inputbin 2 Name
Inputbin 3 Name
Outputbin 1 Name
Def Resolution
Gamma Correction
Enable Buzzer
Page Recovery
Toner Out Act.
Man Feed Timeout
Fig. 4.12 Administration/Engine
Chapter 4
4-46 Printer Configuration
Commentaires sur ces manuels