4. Tilt the SIMM up to a 90° angle until you feel it snap into place
(fig. 8.23). When seated, the SIMM stands upright, firmly in
place. If you cannot snap the SIMM into place, do not force
it. Reposition it, making sure that the bottom of the SIMM is
seated completely in the connector.
5. Repeat steps 2-4 for each additional SIMM you are installing.
6. Replace the printer and controller board covers by following
the steps in the “Replacing the Printer and Controller Board
Covers” section found earlier in this chapter.
..................
..................
..................
..................
.......................
.......................
...................
...................
...................
...................
90
Fig. 8.23 Snap the SIMM into Place
Chapter 8
8-37 Printer Options
Commentaires sur ces manuels