QMS 860 Guide de l'utilisateur télécharger pdf (Page 66)

100

101

A parallel cable has a 36-pin male connector on the printer end and

a 25-pin male connector on the host end. This cable is available

from your QMS vendor. A Dataproducts adapter kit (short-line

only) is also available from your QMS vendor. See chapter 8,

“Printer Options,” for installation instructions.

CAUTION: If you are connecting the printer to a single host, turn

off both systems first.

Use the following procedure to connect your printer to your host

via the parallel port:

1. Attach the 36-pin printer end of the cable to the parallel port

on the printer (fig. 3.3); then close the clips.

2. Attach the other end of the cable to the host’s parallel port.

3. If necessary, use the printer control panel to set up parallel

communication. The factory default parallel settings are

appropriate for most parallel communications. See chapter 4,

“Printer Configuration,” if you need more information.

Testing Parallel Communication

To test communication between your printer and host, first create

a short file that ejects a page from the printer. Then send the file to

the printer.

Printer

Host

36-Pin Female Port

25-Pin Female Port

Fig. 3.3 Host and Printer Parallel Interface Ports

Chapter 3

3-12 Printer-Host Interface

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 397 398

Commentaires sur ces manuels

Pas de commentaire

QMS 860 Guide de l'utilisateur Page 66

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimantes laser/LED QMS 860