QMS 860 Guide de l'utilisateur télécharger pdf (Page 266)

NOTE: After an unformatted disk is formatted and the FORMAT

COMPLETE message displays, you must turn the printer

off and back on again before the printer can recognize the

disk.

Installing an Optional Font or Emulation

CAUTION: If you connect to this printer an external hard disk you

previously used with an earlier QMS Crown printer (QMS 860

release 1, QMS-PS 1700, QMS-PS 2000, QMS-PS 3200, or QMS

ColorScript 210/230 release 1), this QMS 860 software release will

automatically reorganize the files on the hard disk when the printer

is turned back on again. (The printer release number is listed on

both the start-up and the status page.) Once this reorganization is

done, the files on the hard disk can no longer be accessed if the hard

disk is attached to an earlier QMS Crown printer again.

This reorganization process takes time. If, when you first turn the

printer on after attaching a previously used hard disk, it does not

come on line immediately, be patient. Interrupting the reorganiza-

tion process could cause all files on the hard disk to be lost.

Optional fonts and emulations can be installed in two ways:

■ You may use optional fonts or emulations by inserting the

font or emulation card in one of the card slots below the

printer’s paper cassette. However, when you remove the

font or emulation card from the card slot, you can no longer

use those fonts or emulations. This procedure is covered

in the “Using Font and Emulation Cards” section found

earlier in this chapter.

■ You can copy the contents of a font or emulation card to

an external hard disk if one is available. The procedure that

Chapter 8

8-51 Printer Options

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 397 398

Pas de commentaire

QMS 860 Guide de l'utilisateur Page 266